The FAL Files  

Go Back   The FAL Files > Weapon Specific Forums > The HK Files


Thread Tools Display Modes
Old February 09, 2020, 23:07   #1
FALaholic #: 55819
Join Date: Aug 2010
Location: Gamecock Country
Posts: 4,195
G3 flash hider and TD pin question

Is hand tight considered acceptable for the FH, and that little detent spring does all the work? Or is it supposed to be torqued to a spec? The slots in the front are for wire cutting or for a torquing tool?

Also, does anybody know what the proper hole size spec is for the hand guard and rear assembly pushpins? My front HG pushpin is waaaay too tight in the diameter.
Don't spread our wealth around, spread our work ethic.........
Impala_Guy is offline   Reply With Quote
Old February 10, 2020, 06:44   #2
Arrogant Bastard
Gold Contributor
gunplumber's Avatar
FALaholic #: 96
Join Date: Jul 2000
Location: Surprise, AZ
Posts: 26,784
the sling buckle fits the flash hider. Hand tight using the buckle as a wrench - or any scrap of angle iron.

front hole is 6mm for 5.96mm pin
T. Mark Graham, Master Gunsmith
Arizona Response Systems, LLC
gunplumber is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 23:26.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
©1998-2019 The FAL Files