The FAL Files  

Go Back   The FAL Files > Weapon Specific Forums > The AR Files

Notices

Reply
 
Thread Tools Display Modes
Old July 18, 2019, 16:22   #1
ServiceRifle
Registered
Bronze Contributor
 
FALaholic #: 23959
Join Date: Dec 2006
Posts: 1,426
AR15MOLD- DIY molded lower - has anyone done this

Has anyone here done the www.ar15mold.com receiver build?

http://ar15mold.com/freedom-15-5-kit/

Evidently this has been around for a few years but this is the first I've heard of them. I can cut an 80% poly lower in about 15 minutes - but I have always been somewhat ambivalent about poly lowers.
ServiceRifle is offline   Reply With Quote
Old July 18, 2019, 19:00   #2
paulo
Registered
 
FALaholic #: 11856
Join Date: Sep 2003
Location: East Troy Wisconsin
Posts: 572
There was a review a while back in the Shotgun News on these. Review was done in the last three months. Got a favorable review.
paulo is offline   Reply With Quote
Old July 18, 2019, 19:13   #3
ServiceRifle
Registered
Bronze Contributor
 
FALaholic #: 23959
Join Date: Dec 2006
Posts: 1,426
considering the availability of 80% lowers, if I were to buy one I would have to consider it as a fall back - last resort
ServiceRifle is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 05:24.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
©1998-2019 The FAL Files