View Single Post
Old June 03, 2003, 18:14   #4
MasterBlaster
Registered
 
FALaholic #: 10009
Join Date: Mar 2003
Posts: 57
Well it is pretty simple. The mag release has a spot that the spring fits into. Then you slide the two into the ejector block slot which has a place for the other end of the spring. The screw goes through the receiver to hold the mag release in place. Noe you will have to wiggle the mag release until the screw goes through the hole then just tighten the screw. I wish I had a video for you, but I do not. If you play around with it you will figure it out.
__________________
When in doubt...Kill them all and let GOD sort them out!
They would!
MasterBlaster is offline   Reply With Quote