View Single Post
Old November 14, 2019, 20:15   #1
stimpsonjcat
I wasn't talking to you
Silver Contributor
 
stimpsonjcat's Avatar
 
FALaholic #: 470
Join Date: Jul 2000
Location: Dawsonville, GA
Posts: 7,106
New form 1 can build starts...

Drawing:


If you look at the drawing you will see a triangular cross section near the leading edge of the cone. I did that as a means of holding the baffle for cutting the other side using collets to make adjusting/loading easier for that side. Worked great. I will hand scallop that section to be a sort of spiral pattern after I get all the baffles cut.


Here's the test baffle being held in the 1" collet for cutting the downstream concave cone using a boring bar:


The 303 stainless cuts very well with both carbide and HSS.
__________________
"The game is worth the candle...always been."

"Itís hard to light a candle, easy to curse the dark instead."

"Into the light may you fall
Into the light may you follow
Into the light may you know
Truth alone"
stimpsonjcat is offline   Reply With Quote