The FAL Files

The FAL Files (https://www.falfiles.com/forums/index.php)
-   The AUG Files (https://www.falfiles.com/forums/forumdisplay.php?f=145)
-   -   Current AUG muzzle device question? (https://www.falfiles.com/forums/showthread.php?t=451507)

BarnOwlLover March 24, 2020 15:40

Current AUG muzzle device question?
 
I've seen that newer AUGs seem to have standardized on using two piece muzzle devices. Is the reasoning behind that to time the muzzle device to make sure it lines up a certain way without having to mess around with crush washers and such?

Pic of current AUG two piece muzzle brake/flash hider:

https://d2culxnxbccemt.cloudfront.ne...201714/A-6.jpg

1feral1 March 26, 2020 15:49

Standard AUG flash suppressors have always been two piece, though the civilian version is not threaded for a BFA, or has the spring circlip for sealing a rifle grenade.

Also the civvy type, both pieces are removed/installed with a wrench, where the military version has a tool which threads into the muzzle to attach or remove from the rifle, while using a 19mm wrench on the lower two-piece portion holding it steady under force, once the flash slits are lined up, the top portion is held steady, then the lower second portion is tightened. Previously, one must ensure thread locker is used.

BarnOwlLover March 26, 2020 16:32

I'm wondering if it's for device timing (I'm assuming it is), especially since newer AUG muzzle devices are more like a muzzle brake rather than a simple flash hider.

1feral1 March 26, 2020 20:34

Elec/Mech Instructions mention nothing about timing, just removal and installation, which is a common RAEME tasking due to the interbar for M203PI, as the FS must be removed, along with the bayonet standard to install it.

This interbar for the M203PI is only fitted on 508mm rifle barrels, and not 407mm carbine barrels.


All times are GMT -5. The time now is 13:46.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
©1998-2019 The FAL Files