PDA

View Full Version : Need STG buttpad dimensions


Michael64
October 30, 2002, 23:39
Would someone give me some measurements off of a rubber STG buttpad please?

Measure from the backside (the part covered by the stock) top to bottom and side to side. Outside edge to outside edge.

Need to compare this to the Imbel/Belgian pads I've already got.

Most appreciated.

Harlan at FAC
October 31, 2002, 15:12
4.855", about, top to bottom

1.715", about, at its widest width

1.7" across at the bolt hole

tapers down to under 1.2" toward the bottom

Michael64
November 01, 2002, 01:22
Harlan

Thanks for the info.

Dean P
November 01, 2002, 06:31
I have a bunch of STG pads, come on over.

Richard W.
November 01, 2002, 14:43
I would like to replace a ratty IMBEL buttpad with something newer.
Are the STG buttpads the same as the IMBEL's?

Michael64
November 02, 2002, 00:22
Dean
Will probably take you up on that, just need to figure out what my schedule is going to be.

BTW, are those squirrels getting scared/scarce around your parts now? :wink: