|
December 13, 2002, 03:10
|
#1 |
|
Registered
FALaholic #: 3028 Join Date: Mar 2001
Posts: 161
|
WECSOG on a new Tapco III Mount???
OK,
I kept missing Tapco's Gen III mounts, So I bought the chinese junk model. It was ok, but I was never happy. I saw a NIW Tapco gen III mount and jumped all over it. Beautiful and slid right on no problems.... Until I went to put my TA01 ACOG on it....  The damn slots on the mount and the scope base dont line up. I went and looked at the chinese mount and it has different slot spacing from the TAPCO......  I dont know if my trijicon base is STANAG or Weaver, as they are unmarked. And I dont know if the Chinese (and all my other AR screw on rails) are STANAG/WEAVER combined. But the scope mount fits all except the TAPCO.... Not to worry, the dremel is waiting to open up one slot to accept the mount, but I just cant figure out why. I wouldnt know a STANAG if it stole my car, but I am figuring that has got to have something to do with it.... Am I way off base and its something simple or am I guessing in the right direction? Thanks for any help.... |
|
|
|
December 13, 2002, 15:10
|
#2 |
|
Registered
FALaholic #: 3028 Join Date: Mar 2001
Posts: 161
|
35 views and no guesses? anybody?
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
