Bore good? bad?

7.62 4U · October 17, 2002, 13:24

Is there any other way, or better ways to check rifle bores for ware than just visual inspections?

**EMDII** · October 17, 2002, 15:37

Borescope and pulloever, or air-gauge.

Visual:
- shiny, lands and grooves sharp/clearly defined
- tight muzzle
- no frost or pitting
- good chamber cast

These techniques provide good indications

7.62 4U · October 18, 2002, 14:58

Thanks, Was thinking of cutting it down to 16.5 brush gun size.
Was unsure of cond.(G1) Looks clean with ware.

October 17, 2002, 13:24	#1
7.62 4U Registered FALaholic #: 6351 Join Date: May 2002 Location: Ohio Posts: 16	Bore good? bad? Is there any other way, or better ways to check rifle bores for ware than just visual inspections? __________________ Lock & Load!

October 17, 2002, 15:37	#2
EMDII Evil Moderator Silver Contributor FALaholic #: 6 Join Date: Jul 2000 Location: Kennesaw, GA Posts: 13,971	Borescope and pulloever, or air-gauge. Visual: - shiny, lands and grooves sharp/clearly defined - tight muzzle - no frost or pitting - good chamber cast These techniques provide good indications __________________ "The Spartans do not enquire how many enemy there are. The SPartans merely enquire WHERE they are." E.M. (Ted) Dannemiller II 1*

October 18, 2002, 14:58	#3
7.62 4U Registered FALaholic #: 6351 Join Date: May 2002 Location: Ohio Posts: 16	Thanks, Was thinking of cutting it down to 16.5 brush gun size. Was unsure of cond.(G1) Looks clean with ware. __________________ Lock & Load!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode