Brownell's Baking Lacquer

Gaspipe · October 06, 2002, 21:16

This is for Buff:

The top cover, lower, butt, charging handle, selector, takedown lever, pivot pin and sight assembly are as it came from Argentina. The upper receiver, barrel, handguard ring, mag release, and triggerguard are Brownell's finished parts.

The mag is one of the TAPCO G1 mags from one of the 10 each boxes. Also matches nicely.

I can't tell the difference. My kit from FWRA was so nice, I am not going to refinish those other parts now.

HTH,

**sportsnut** · October 06, 2002, 23:27

Bruce, hows she run? What barrel did you go with?

**BUFF** · October 07, 2002, 00:44

Thanks, guys. I bought a Grade I kit from Dan's and am about to order an IMBEL upper. The finish on the kit is really, really nice and I figure I will want to refinish the parkerizing on the receiver to match it. Then, touch up the brake/muzzle area after the f/h leaves and the brake arrives.

Gaspipe · October 07, 2002, 09:15

I haven't put in a locking shoulder yet [or a bolt for that matter] because I haven't decided how to pin the folding stock open, to satisfy our elected and appointed champions of good taste.

I went with a 18" Steyr barrel from DSA and a FSE fake Belgian style FH.

October 06, 2002, 21:16	#1
Gaspipe Registered FALaholic #: 2131 Join Date: Jan 2001 Location: South of the Mason Dixon Line Posts: 610	Brownell's Baking Lacquer This is for Buff: The top cover, lower, butt, charging handle, selector, takedown lever, pivot pin and sight assembly are as it came from Argentina. The upper receiver, barrel, handguard ring, mag release, and triggerguard are Brownell's finished parts. The mag is one of the TAPCO G1 mags from one of the 10 each boxes. Also matches nicely. I can't tell the difference. My kit from FWRA was so nice, I am not going to refinish those other parts now. HTH, __________________ gaspipe [the original]

October 06, 2002, 23:27	#2
sportsnut Curio & Relic Contributor FALaholic #: 3817 Join Date: Aug 2001 Location: Eugene, Oregon Posts: 3,360	Bruce, hows she run? What barrel did you go with? __________________ "Just because you're right doesn't mean I'm wrong." Ron W.

October 07, 2002, 00:44	#3
BUFF Old Fart Silver Contributor FALaholic #: 789 Join Date: Aug 2000 Location: Salt Lake City, Utah Posts: 7,135	Thanks, guys. I bought a Grade I kit from Dan's and am about to order an IMBEL upper. The finish on the kit is really, really nice and I figure I will want to refinish the parkerizing on the receiver to match it. Then, touch up the brake/muzzle area after the f/h leaves and the brake arrives. __________________ BUFF

October 07, 2002, 09:15	#4
Gaspipe Registered FALaholic #: 2131 Join Date: Jan 2001 Location: South of the Mason Dixon Line Posts: 610	I haven't put in a locking shoulder yet [or a bolt for that matter] because I haven't decided how to pin the folding stock open, to satisfy our elected and appointed champions of good taste. I went with a 18" Steyr barrel from DSA and a FSE fake Belgian style FH. __________________ gaspipe [the original]

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode