LIght Primer Strike After Falcon Arms TPR Kit

Shatuponthee · September 18, 2011, 13:09

I just tested out my Falcon Arms Trigger Pull Reduction Spring Kit. The results in terms of trigger improvement were excellent. I was concerned that the hammer spring replacement would result in a light primer strike.

The kit was installed on a DSArms STG58 18C, I was shooting Argentian Surplus. Out of 18 rounds fired only one had a light primer strike. Granted these are very hard pirmers. The rifle prior to this range session had only 60 rounds fired through it.

Has anyone had this problem, or is it a break in issue? Thanks for your comments.

**msnyder** · September 18, 2011, 13:16

I've only experienced this once. I pulled the hammer spring out and found out it was shorter than standard. Put new hammer spring in and problem went away.

September 18, 2011, 13:09	#1
Shatuponthee Registered FALaholic #: 63163 Join Date: Mar 2011 Location: El Paso, TX Posts: 5	LIght Primer Strike After Falcon Arms TPR Kit I just tested out my Falcon Arms Trigger Pull Reduction Spring Kit. The results in terms of trigger improvement were excellent. I was concerned that the hammer spring replacement would result in a light primer strike. The kit was installed on a DSArms STG58 18C, I was shooting Argentian Surplus. Out of 18 rounds fired only one had a light primer strike. Granted these are very hard pirmers. The rifle prior to this range session had only 60 rounds fired through it. Has anyone had this problem, or is it a break in issue? Thanks for your comments.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

September 18, 2011, 13:16	#2
msnyder Curio & Relic Bronze Contributor FALaholic #: 1085 Join Date: Sep 2000 Location: New Mexico Posts: 2,856	I've only experienced this once. I pulled the hammer spring out and found out it was shorter than standard. Put new hammer spring in and problem went away.