.223 NM loads?

panzer · June 08, 2008, 18:34

Looking for a good proven .223 service rifle load for a 1-8 twist. 68-69 grains. H335 preffered as it is what I have..

mj2evans · June 08, 2008, 18:40

Check Sierra site. The powders of choice for most HP shooters seem to be Varget, RL15, and H4895.

Some good reloading info can be found at:
http://www.njhighpower.com/

**DesertFALrat** · July 21, 2008, 15:54

H335 works good for 55g FMJ blastin ammo.

For match loads, I didn't have much luck with H335. The best accuracy load was at 21 grains.

It was really slow (~2400fps), and not good for anything past 200yrds. High Std Deviations as well.

Loaded with Sierra and Hornady 69g and 75g HPBT in LC cases and a CCI mil primer.

By contrast, I now just use 24.5g H4895 and have great results.

hagar · July 21, 2008, 16:54

You need a slower powder than H335.

Varget or RL15 rules, 25 grains of either (near max load) with Rem 7.5 primer, LC case and 68 or 69 grain bullet seated to 2.255 oal. Don't use the CCI #41 military primer with this load, it is too hot! And don't use Winchester primers either, it WILL slam fire with an AR15.

panzer · July 21, 2008, 16:57

I ended up with 25.3 of Varget, rem cases, cci std primers 2.250 OAL. I get 2950 fps, and about .5 moa out of it.

Any good 52 grain loads? H322 or Varget or H4895? those are the powders I have, and I hate ball powders.

June 08, 2008, 18:34	#1
panzer Registered FALaholic #: 1988 Join Date: Dec 2000 Location: SMYRNA ,GA,THE BEST COUNTRY Posts: 2,119	.223 NM loads? Looking for a good proven .223 service rifle load for a 1-8 twist. 68-69 grains. H335 preffered as it is what I have.. __________________ http://militarysignatures.com/signatures/member865.png "Also I heard the voice of the Lord saying who shall I send, and who will go for us? Then said I, here am I, send me." -Isaiah 6:8

July 21, 2008, 16:57	#5
panzer Registered FALaholic #: 1988 Join Date: Dec 2000 Location: SMYRNA ,GA,THE BEST COUNTRY Posts: 2,119	I ended up with 25.3 of Varget, rem cases, cci std primers 2.250 OAL. I get 2950 fps, and about .5 moa out of it. Any good 52 grain loads? H322 or Varget or H4895? those are the powders I have, and I hate ball powders. __________________ http://militarysignatures.com/signatures/member865.png "Also I heard the voice of the Lord saying who shall I send, and who will go for us? Then said I, here am I, send me." -Isaiah 6:8

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

June 08, 2008, 18:40	#2
mj2evans Registered FALaholic #: 11922 Join Date: Sep 2003 Location: Dallas, TX Posts: 1,084	Check Sierra site. The powders of choice for most HP shooters seem to be Varget, RL15, and H4895. Some good reloading info can be found at: http://www.njhighpower.com/

July 21, 2008, 15:54	#3
DesertFALrat FN Nuts Bronze Contributor FALaholic #: 10982 Join Date: Jun 2003 Location: Arizona Posts: 570	H335 works good for 55g FMJ blastin ammo. For match loads, I didn't have much luck with H335. The best accuracy load was at 21 grains. It was really slow (~2400fps), and not good for anything past 200yrds. High Std Deviations as well. Loaded with Sierra and Hornady 69g and 75g HPBT in LC cases and a CCI mil primer. By contrast, I now just use 24.5g H4895 and have great results.

July 21, 2008, 16:54	#4
hagar Registered FALaholic #: 228 Join Date: Jul 2000 Location: Columbia, SC Posts: 6,691	You need a slower powder than H335. Varget or RL15 rules, 25 grains of either (near max load) with Rem 7.5 primer, LC case and 68 or 69 grain bullet seated to 2.255 oal. Don't use the CCI #41 military primer with this load, it is too hot! And don't use Winchester primers either, it WILL slam fire with an AR15.