|
February 22, 2007, 23:35
|
#1 |
|
Registered
FALaholic #: 1988 Join Date: Dec 2000
Location: SMYRNA ,GA,THE BEST COUNTRY
Posts: 2,119
|
Need AK gas port drilled. + more
Who can drill a gas port for my M92 krink kit and press it into the trunion to set headspace? This is all I need done, set HS in trunion, and drill gas port and press front sight base on. This is from an all new M92 kit . Thanks!
__________________
http://militarysignatures.com/signatures/member865.png "Also I heard the voice of the Lord saying who shall I send, and who will go for us? Then said I, here am I, send me." -Isaiah 6:8 |
|
|
|
February 23, 2007, 20:04
|
#2 | |
|
Registered
FALaholic #: 6893 Join Date: Jul 2002
Location: Peoples Republic of Maryland
Posts: 1,341
|
Re: Need AK gas port drilled. + more
Quote:
The chamber end of the barrel has to be relieved for extractor clearance. The rear sight base needs to be pressed and drilled for the pin. The front sight base needs to be drilled for pins as well. And finally the trunion needs to be drilled for the barrel pin and the holes for the rivets.
__________________
Without the Second Amendment to the Constitution, there is no first. |
|
|
|
|
|
February 23, 2007, 20:07
|
#3 |
|
Registered
FALaholic #: 1988 Join Date: Dec 2000
Location: SMYRNA ,GA,THE BEST COUNTRY
Posts: 2,119
|
I want everything done to it except put in the reciever. As I need to get reciever and SBR it. So I want all the barrel stuff done so I can get a reciever and SBR it then assemble. Its alot of hassle to do it the opposite way. I have everything I need to put it together except the parts you mentioned, minus the reciever mounting.
__________________
http://militarysignatures.com/signatures/member865.png "Also I heard the voice of the Lord saying who shall I send, and who will go for us? Then said I, here am I, send me." -Isaiah 6:8 |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
