|
August 21, 2001, 20:29
|
#1 |
|
Registered
FALaholic #: 3404 Join Date: Jun 2001
Location: Indy
Posts: 951
|
Tapco's New lower recievers
I bought one of Tapco's new in the wrapper lower. It is absolutely perfect. Great park, both stud and recoil tube. My question is, is it a standard metric or is it a STG58/G1. Can owners of true FN's and STG58's measure the distance between the leading edge of the front sight ramp and the bottom of the reciever with a mic/caliper and give us the distances? I know an STG58 is NOT parallel while a metric is. BTW, which sights do I use?
|
|
|
|
August 21, 2001, 21:54
|
#2 |
|
Registered
FALaholic #: 46 Join Date: Jul 2000
Location: Texas
Posts: 3,652
|
Hey Indycar, both the STG and the G1's used the low sight lines so the sights are the same.HTH
|
|
|
|
August 21, 2001, 22:07
|
#3 |
|
Registered
FALaholic #: 5 Join Date: Jul 2000
Location: In a van down by the river
Posts: 2,216
|
If you mean the shoulder below the rear sight, the G1s will be parallel same as FN made Fals. The Austrian Stg lower has a more angled shoulder which can cause mismatch between lower and buttstock when FN and Austrian lower/buttstocks are interchanged.
The top lower is G1, middle FN made Stg, both with with straight shoulder below rear sight. The bottom lower is Austrian Stg with angled shoulder.
__________________
Mr pogo has left the building.... |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
