|
September 02, 2004, 17:59
|
#1 |
|
Registered
FALaholic #: 13431 Join Date: Feb 2004
Location: Newcastle CA
Posts: 1,436
|
para bolt carrier/ dust cover
Does the para bolt carrier/ dust cover require one particular reciever type? Or should it fit on type I, II, and III. The nipple formed ot the front of the dust cover to retain the carrier will not fit within the recess of a CAI reciever, type III. Someone please elucidate me
__________________
Pacifism is the abdication of life. Am fear nach gleidh na h-airm san t-sith, cha bhi iad aige 'n am a' chogaidh. |
|
|
|
September 02, 2004, 18:06
|
#2 |
|
Registered
FALaholic #: 167 Join Date: Jul 2000
Location: Gardnerville , NV. Near Lake Tahoe
Posts: 1,826
|
The Para Dust Cover -- All receivers must be machined/milled for this to fit.
Receiver type & make e.g. I,II,III Most Smiths charge approx. $50 + shipping
__________________
Will work for cash & pine nuts |
|
|
|
|
September 02, 2004, 18:10
|
#3 |
|
Registered
FALaholic #: 13431 Join Date: Feb 2004
Location: Newcastle CA
Posts: 1,436
|
Yes, I just found info on it. Upper reciever para cut. Well, now I got work to do...
Hmmm, my dremel... 
__________________
Pacifism is the abdication of life. Am fear nach gleidh na h-airm san t-sith, cha bhi iad aige 'n am a' chogaidh. |
|
|
|
|
September 02, 2004, 21:06
|
#4 |
FALaholic #: 1125 Join Date: Sep 2000
Location: Here right now
Posts: 17,638
|
DSA sells a para-cover and scope cover that do not require milling the receiver.
Vince |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
