Need help to get started on casting.

wales · February 28, 2004, 17:49

I have a raw casting receiver. What should be the first cut and were should the base measurements be taken from?

Steve A. Reno · February 28, 2004, 18:09

Yo wales, try this link, should answer all your questions:
http://www.roderuscustom.tzo.com/cgi.../ikonboard.cgi ...SAR.

Guttertroop · February 28, 2004, 20:09

That is a great website.

wales · February 29, 2004, 07:32

Thanks it is a great site.

February 28, 2004, 17:49	#1
wales Registered FALaholic #: 9557 Join Date: Feb 2003 Location: nc Posts: 23	Need help to get started on casting. I have a raw casting receiver. What should be the first cut and were should the base measurements be taken from?

February 28, 2004, 18:09	#2
Steve A. Reno Registered FALaholic #: 8461 Join Date: Dec 2002 Location: Left Coast, U. S. of A. Posts: 115	Yo wales, try this link, should answer all your questions: http://www.roderuscustom.tzo.com/cgi.../ikonboard.cgi ...SAR. __________________ "Always remember that you are unique, just like everyone else" Peter Melnick

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

February 28, 2004, 20:09	#3
Guttertroop Banned Marketplace Complaints FALaholic #: 13320 Join Date: Jan 2004 Location: KY Posts: 64	That is a great website.

February 29, 2004, 07:32	#4
wales Registered FALaholic #: 9557 Join Date: Feb 2003 Location: nc Posts: 23	Thanks it is a great site.