The FAL Files  

Go Back   The FAL Files > Weapon Specific Forums > CZ Firearms - Czech it out!

Notices

Reply
 
Thread Tools Display Modes
Old October 06, 2017, 23:06   #1
Ghost
Registered
 
Ghost's Avatar
 
FALaholic #: 1273
Join Date: Oct 2000
Location: Colorado/Utah
Posts: 1,258
building a VZ58?

Wondering who has built a VZ58 clone? Im thinking about it. I'm curious how headspace is set. I've seen mention of the use of shims under the locking block? That doesnt seem like a good solution.
How was it set at the factory?
can we set it the same way?
How is the CNC warrior receiver?
and is there a jig to rivet the triger housing?

Thanks
Ghost is online now   Reply With Quote
Old October 07, 2017, 01:45   #2
ftierson
Registered
 
FALaholic #: 13827
Join Date: Mar 2004
Location: Colorado Springs, CO
Posts: 15,195
You just plug the barrel into the front of the receiver until your headspace is correct with the bolt you're using, just like an AK...

Forrest
ftierson is offline   Reply With Quote
Old October 11, 2017, 14:08   #3
Dirt1042
Registered
 
FALaholic #: 21859
Join Date: Nov 2006
Location: Montana
Posts: 4,272
I had a kit built by Sledgehammer here on the files. The cnc warrior receiver is good but has a tight mag fit after refinishing. Which is better than being sloppy. Love the rifle
__________________
ORO Y PLATA!
~Pain By Steel Rain~ R 5/10 2nd Mar Div
Dirt1042 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 15:00.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
©1998-2015 The FAL Files