The FAL Files  

Go Back   The FAL Files > Discussion Forums > Marketplace

Notices

Reply
 
Thread Tools Display Modes
Old May 15, 2019, 14:22   #1
lew
Registered
Contributor
 
lew's Avatar
 
FALaholic #: 16727
Join Date: Jan 2005
Location: Phoenix, AZ
Posts: 8,464
WTT: SA, RA FAL parts- most of a kit- for Swiss K31

DEAL PENDING

Howdy,

I was going to build these parts into a complete FAL, but I already have five FALs and little interest in another. So, instead of these sitting around as spare parts, I want to trade them for a Swiss K31 in 7.5x55mm Swiss. Pictures available on request.

-South African 17.3” barrel and gas block. Chopped, blasted, and refinished by Mark Graham. A couple light pits in bore just in front of the gas block. VG+

-South African wood stock, with steel buttplate and long buttplate screw, a couple drilled-out SADF markings near the wrist, well coated in tung oil, G+

-HTS: South African trigger, drilled “UM” mark, bit of Rhodesian green paint; surplus hammer, sear (not cast)

-StG-58 extractor, like-new

-Firing pin, surplus, like-new, parkerized

-Takedown latch

-South African gas tube, paint-over-parkerizing, GC

-Inner/outer recoil springs, plunger. surplus

-Type D synthetic stock, standard length, remnants of a rack number, GC rubber buttpad

-Type D synthetic stock, standard length, no markings. Excellent condition

-DSA Ti combo device flash hider, like-new

-DSA Bipod-cut handguards, never used

-Non-bipod-cut handguards, small interior crack repaired with epoxy, lined with Aluminum reflective tape, no paint. G+

-Pistol Grip, surplus. VG

-FN bolt with crown markings, Rhodesian Army number. VG

-South African Bolt carrier with markings, rat tail; bottom of carrier rails chromed. VG

-South African dust cover, moderate wear, remnants of green Rhodesian paint along the length in the "valleys" on both sides

-Complete CH assembly, curved slide, paint-over-parkerizing. VG

-SA grenade sight gas plug. moderate wear GC

-Hinge/joint pin. VG

This offer is all-or-nothing. I will not part anything out.

Most everything from a parts kit minus the receivers, gas piston, HTS plate, hammer strut, extractor plunger, and a handful of springs.

Thanks for looking. Cheers!

DEAL PENDING
__________________
Statism: Ideas so great, they're mandatory.

"What can be asserted without evidence can be dismissed without evidence." -Christopher Hitchens

"Democracy is the theory that the common people know what they want, and deserve to get it good and hard." -H.L. Mencken

Last edited by lew; May 15, 2019 at 17:26.
lew is online now   Reply With Quote
Old May 15, 2019, 16:00   #2
Grahamneall
Senior Member
Gold Contributor
 
FALaholic #: 62175
Join Date: Dec 2010
Location: Austin, Texas
Posts: 809
PM sent
Graham
Grahamneall is online now   Reply With Quote
Old May 15, 2019, 17:10   #3
Grahamneall
Senior Member
Gold Contributor
 
FALaholic #: 62175
Join Date: Dec 2010
Location: Austin, Texas
Posts: 809
I'll take it all
Per our PM.
Graham.
Grahamneall is online now   Reply With Quote
Old May 15, 2019, 17:11   #4
imacoonass01
Veteran Member
Silver Contributor
 
imacoonass01's Avatar
 
FALaholic #: 80275
Join Date: Nov 2017
Location: Vidor, TX
Posts: 1,744
Congrats to both!
__________________
“You may all go to hell and I will go to Texas.” - - Davy Crockett
imacoonass01 is online now   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 06:39.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
©1998-2018 The FAL Files