The FAL Files  

Go Back   The FAL Files > Weapon Specific Forums > The HK Files


Thread Tools Display Modes
Old December 16, 2012, 21:32   #1
FALaholic #: 20374
Join Date: Jun 2006
Posts: 1,027
Re-installing The Plastic Buttplate On A Regular Fixed G3 Stock?

Trying to install the regular plastic buttpad/buttplate on a fixed green G3 buttstock....

It is my understanding the only thing that attaches the buttplate to the stock are the spring clips on the buttplate that grab onto the two rails inside the stock (these are the rails that form the grommet holes on the exterior of the stock--the ones that hold the buttstock pushpins while one does maintenance on the rifle).

My question is, am I supposed to be able to push/force the springs of the buttplate onto the rails inside the buttstock by hand, or am I going to need a vise of some sort and a mallet? It seems to be a pretty tight fit.

(Also BTW the only reason I'm trying to go this route instead of simply doing a full swap with one of the $10 complete buttstock assemblies out there is that I'm trying to switch the furniture on the rifle to the tropical green color as opposed to the OD green color it has now).
wkendwarrior2003 is offline   Reply With Quote
Old December 16, 2012, 21:41   #2
superjc's Avatar
FALaholic #: 30508
Join Date: Jul 2007
Location: Sacramento, California
Posts: 956
Never tried separating stock from rear plate but finding out that a long screw held the stock/buffer to the plate was a BIG help in getting it all apart to put on
my Magpul stock:

superjc is online now   Reply With Quote
Old December 16, 2012, 23:16   #3
Feeding the addiction
Silver Contributor
hkshooter's Avatar
FALaholic #: 5391
Join Date: Jan 2002
Location: Central Indiana
Posts: 4,311
The butt plate just snaps on, takes some effort. Align the pad like you have been then place the butt pad on the floor. Put your weight on the stock and shove. Should snap right back on.
hkshooter is online now   Reply With Quote
Old December 17, 2012, 10:33   #4
Arrogant Bastard
Gold Contributor
gunplumber's Avatar
FALaholic #: 96
Join Date: Jul 2000
Location: Surprise, AZ
Posts: 20,715
do it at a slight angle so you aren't pushing against both spring clips at the same time, but one slightly before the other.
T. Mark Graham
Master Gunsmith
Arizona Response Systems, LLC
gunplumber is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump

All times are GMT -5. The time now is 02:14.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
©1998-2015 The FAL Files