|
October 28, 2010, 13:34
|
#1 |
|
Registered
FALaholic #: 56454 Join Date: Aug 2010
Location: Escondido, CA
Posts: 14
|
time my flash hider to my argy
I got a DSA Belgian flash hider and am ready to install on my argy barrel. Question is how do I time it? I assume the notch goes at the 6 O clock position, but when fully screwed on it ends up around 11:30. Am I supposed to use some kind of indexing washer? I was gonna just lock-tite it short of fully screwed on at the 6 o clock position, but the thread fit is a bit sloppy and I am afraid I will not get it perfectly concentric and maybe affect accuracy?
What should I do? |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode