View Single Post
Old April 13, 2018, 09:31   #9
Holescreek
Registered
 
FALaholic #: 51475
Join Date: Jan 2010
Location: Centerville, OH
Posts: 202
Quote:
Originally Posted by lakipolitis View Post
Hmmm. I'm trying to learn as much as fast as I can before I jump into this project. Would a ground bolt head, but with a bolt face that did not fail headspacing, require replacing the bolt?
The extra .011" has to be factored in to the gap measurement if a ground bolt head is used. Instead of the .004"~.020" spec used with full length bolt heads a ground head would change the spec to .015"~.031" in order to position the bolt locking lever properly on the ramp of the bolt.

Holescreek is offline   Reply With Quote