View Single Post
Old June 10, 2006, 22:20   #6
Dakota FAL
Registered
 
FALaholic #: 20223
Join Date: Jun 2006
Location: VA and NC
Posts: 196
I'm not sure what you are shooting, but the worst I've ever had is a stove pipe and/or a dent in the neck of the case. I'd prefer to beat up a few cases than beat the rifle with excess gas until I get a failure to fully cycle the bolt.

I've never had a problem with the bolt ramming the case back into the chamber and if it did, it isn't going to stick unless rifle and or ammunition is very dirty. Just a suggestion, but if the case does end up back in the chamber, unfold the little thingy on the side and try pulling the bolt back before you start slamming the butt on the ground.
Dakota FAL is offline   Reply With Quote