View Single Post
Old May 16, 2018, 17:04   #15
Wildcat
Registered
 
FALaholic #: 6517
Join Date: May 2002
Posts: 965
Quote:
Originally Posted by CG&L View Post
Poor metallurgy is more likely than an overloaded cartridge. This has happened far too many times with Taurus/Rossi J frames using factory ammo.

Pin gauges would work fine. Diameter and depth are the numbers I need. Strange you think this wouldn't work. Do you have a shop and do this kind of work? I do.
I could easily cast the chambers and get all the number I need
Respectfully, the pin gauge will only tell you diameter of the largest inscribed cylinder that will fit into a bore and perhaps to some depth.

It will not tell you if the bore is out of round.
It will not tell you where the bore is out of round.

You need another instrument for that.
__________________
"A cool man with a rifle, if he has mastered his weapon, need fear no foe." - Theodore Roosevelt
Wildcat is online now   Reply With Quote