View Single Post
Old July 14, 2017, 15:39   #16
4markk
Military Observer
Gold Contributor
 
4markk's Avatar
 
FALaholic #: 31134
Join Date: Aug 2007
Location: Army of Occupation of Northern Virginia
Posts: 4,695
Ok here is the new law in California:

SECTION 1. Section 30515 of the Penal Code is amended to read:

30515. (a) Notwithstanding Section 30510, “assault weapon” also means any of the following:
(1) A semiautomatic, centerfire rifle that does not have a fixed magazine but has any one of the following:[list of comestic features that give leftist nightmares]

[]

(b) For purposes of this section, “fixed magazine” means an ammunition feeding device contained in, or permanently attached to, a firearm in such a manner that the device cannot be removed without disassembly of the firearm action.


This could be easy for the FAL. If you ran a set screw down the right side of the ejector block you can lock the mag release in place. I'm think cut a half cylinder in the guide post, drill and tap the hole flush on top with the BOH hole on top, and screw in a set screw long enough to prevent the mag release from moving.

Then it would require you disassemble the action to release the mag (break it open, removed the top cover, remove the bolt/carrier group, and remove the set screw).

Attached Images
File Type: jpg CA Compliant Ejector-lo.jpg (65.5 KB, 120 views)
__________________
`
`
The difference between the possible and the impossible is only in the degree of a man's will. Chinese Proverb

“The worst thing about growing old is that other men stop seeing you as dangerous.” Act Of Valor

"A wise man gets more use from his enemies than a fool from his friends." Socrates

Last edited by 4markk; July 14, 2017 at 16:29.
4markk is online now   Reply With Quote