View Single Post
Old December 28, 2017, 00:13   #37
Falfan2017
Registered
 
FALaholic #: 79031
Join Date: Jan 2017
Location: Gulf Coast, MS
Posts: 676
Here's a quick way to deal with rifle brass. Set up a decapper die or a sizing die with a decal pin. On another station in a progressive press use the lee quick trim with drill attachment. Then you're decapping and sizing and trimming all at once. I don't bother measuring to see if they need a trim. If they are already short enough it won't cut them too deep. Then I run them through the Dillion super swags if they are crimped and then into the tumbler for a clean up and remove the lube. Then you got prepped brass.
Falfan2017 is offline   Reply With Quote