View Single Post
Old April 04, 2010, 15:56   #65
Kyrottimus
Registered
 
Kyrottimus's Avatar
 
FALaholic #: 18036
Join Date: Aug 2005
Location: Montana
Posts: 3,015
I think maybe put marks on the back of the mag where one could drill out for witness holes if they wanted, shouldn't be too hard with a basic drill once the mag is disassembled.

So no, I wouldn't personally want default witness holes but having pre-marked numbers 5, 10, 15, 20, 25 with little starter-divots or "x's" next to them (as a mark of where to drill) would be a best option.

And if adding those marks is too much work or cost, I'd just go without them and if I ever did want them, I'd personally measure cartridge offset with masking tape and drill my own holes where I wanted (and used that mag as a template for the other's).
__________________
Anomaly in Progress
Esto Perpetua; Semper Armatus, Semper Liberi
Kyrottimus is offline   Reply With Quote