PDA

View Full Version : FAL muzzle break shims/crush washer?


boeuzi
October 22, 2017, 12:19
I just got a metric DSA FAL and I need a set of shims to time the muzzle break! Any one know where to get these shims? Do you know the right size? its not 5/8 or 9/16. The thread size is 9/16 x 24 left hand. Thanks :fal::confused: ...... up date I was told that it doesn't take shims or a crush washer. But the muzzle break need to be machined? Any one know any thing about that? Any gunsmith's in Southern California?

lew
October 23, 2017, 12:36
I've used red Loctite on two of my FAL's. Even after a few hundred rounds each, the combo devices are still where I left 'em.

Lee Carpentieri
October 24, 2017, 11:07
ALLOT OF PEOPLE CUT A PAPER CLIP TO THE INTERNAL SIZE OF THE 22MM COMBO DEVICE/MUZZLE BRAKE. SO IF YOU HAVE A PAIR OF WIRE CUTTERS,HAVE AT IT.