PDA

View Full Version : GB find


aussiedave
October 18, 2017, 05:18
http://www.gunbroker.com/Item/709646616

Is this worth it,

msu89dawgs
October 18, 2017, 09:06
Not sure if it's one of the ones discussed in the thread below, but I wouldn't risk it.

http://www.falfiles.com/forums/showthread.php?t=349993

Lee Carpentieri
October 18, 2017, 13:17
Look at the locking hole, It's a CAI reject.

djfin
October 18, 2017, 13:40
Not as CAI reject. That's the same cut on the locking shoulder that they ship out. Not saying it's not a POS but just not a reject based on that cut

Flypaper
October 18, 2017, 13:45
I had one with the locking shoulder cut into the type 1 cut. The bolt carrier rails were .020 lower than a FN receiver. I had to take the knob off the bottom of the bolt carrier and grind the bolt to get it to work. After a lot of time, it worked but it wasn’t worth it.

4markk
October 18, 2017, 18:19
They are junk .... not a beginners project.

http://www.falfiles.com/forums/showthread.php?t=361192