View Full Version : gas block instilation
June 19, 2002, 12:45
just how do you remove the gas block and put it on another barrel?thanks for any replys
June 19, 2002, 12:46
i have a g1 barrel but have decided too use an argie barrel,it does not have the gas block installed and the g1 does but i want too switch them
June 19, 2002, 16:25
The best way is to remove the pin and press it out . But I have used a BFG and a piece of small angle iron ( 1X1 ? ) . I went around the diameter of the gas block on that tiny lip it has .
To re-install is the tricky part . I used a hot air gun ( at work we use it for some bearings ) , an oven should work . I heated up the gas block to expand the O.D. , so I could slip it over the barrel and position it for the cross pin , before it cools and shrinks .
Good luck ,
June 19, 2002, 17:27
You click the search button at the top of the page, enter "remove gas block," and find dozens of great suggestions LIKE THESE (http://www.falfiles.com/forums/showthread.php?s=&threadid=16617)
vBulletin® v3.8.7, Copyright ©2000-2015, vBulletin Solutions, Inc.