PDA

View Full Version : building a VZ58?


Ghost
October 06, 2017, 23:06
Wondering who has built a VZ58 clone? Im thinking about it. I'm curious how headspace is set. I've seen mention of the use of shims under the locking block? That doesnt seem like a good solution.
How was it set at the factory?
can we set it the same way?
How is the CNC warrior receiver?
and is there a jig to rivet the triger housing?

Thanks

ftierson
October 07, 2017, 01:45
You just plug the barrel into the front of the receiver until your headspace is correct with the bolt you're using, just like an AK...

Forrest

Dirt1042
October 11, 2017, 14:08
I had a kit built by Sledgehammer here on the files. The cnc warrior receiver is good but has a tight mag fit after refinishing. Which is better than being sloppy. Love the rifle