View Full Version : Easy way to fit inch selector to metric lower
June 18, 2002, 18:34
I have been playing around some of my parts and found that you can put a inch trigger in the metric lower then you can put a inch selector in the metric frame and it will work fine. The only real modification I had to make was round off the bottom of the inch trigger so it would fit in the metric trigger gaurd. I have the complete trigger for sale at $8 that inlcudes the trigger, spring and sear.
June 18, 2002, 23:19
OK, well, what am I missing here??? I installed an Inch selector on my Metrinch/Izzy Carbine. R1 Metric lower - just had to file down a nub on the lower. All other HTS is metric and with over 700 rounds through her she is going strong.
June 18, 2002, 23:36
kinda same same here. i just ground of a little nub on the selector and it sliped right in.
June 19, 2002, 01:43
I think the important part of this post is the fact that you put an inch trigger in a metric lower! That's a new one as far as I know. Of course, I might have missed someone posting that info before but everything I have heard so far has been that inch and metric FTS parts are not interchangeable. Guess I'll have to get out the two parts and check it out.
June 19, 2002, 09:57
Hey, I think that everyone is missing what Rhineland 1 is trying to say,He put a Indian L1A1 trigger and Indian L1A1 selector lever in a Metric reciever,The Indian L1A1 rifles are a MIX of Inch and Metric parts and thats why they work in the Metric lower.HTH
vBulletin® v3.8.7, Copyright ©2000-2013, vBulletin Solutions, Inc.