PDA

View Full Version : Locking shoulder issues


3Gunnah
September 19, 2017, 21:06
Finally got my L1 A1 barreled up and ready to go. It is an Imbel inch cut. I currently have a .260 locking shoulder which is giving me a very easy bolt closure. I'm quite sure moving to a .261 will give me the headspace I am looking for. The issue is the Locking shoulder I currently have will easily slide in and out of the receiver. Spinning it in the calipers on the ends gives me a measurement of .294 just trying to confirm that I should need a number three oversized based on the charts I am seeing. Thanks

MAINER
September 20, 2017, 08:33
The L1A1 chart I have doesn't list .294" as a shaft dia. The smallest is .2978" followed by .2982", .2990", and .2998".


Possibly you misread your calipers or somebody has been monkeying with that LS?

3Gunnah
September 20, 2017, 09:36
Actually now that you mention it as I'm driving I'm thinking that I may have recalibrated them to use with a bullet comparator and not set the dial back to zero. I will check again this evening. thanks that could have been an expensive mistake.

3Gunnah
September 20, 2017, 18:47
All good they were off. Just need a first oversized.
Thanks

308/223shooter
September 20, 2017, 20:29
Pm sent.