PDA

View Full Version : Hopco HT01 & Burris Fastfire 3 on BM 59


SteelGreyML
February 08, 2017, 14:05
Final got it:
http://i.imgur.com/KANoi5m.jpg?1
http://i.imgur.com/srrvehr.jpg?1
http://i.imgur.com/jJS7MhY.jpg?2

01BIRDDOG
February 08, 2017, 18:05
I like the look and what it provides. How did it effect your cheek weld on the stock?

Jarhead504
February 08, 2017, 20:34
I like that a lot too. If you would not mind, please tell us how you got it on the rifle. Was it very difficult? Are you going to use a rising cheekpiece with it?

TIA,
Jarhead

SteelGreyML
February 08, 2017, 20:36
I like the look and what it provides. How did it effect your cheek weld on the stock?

Thanks. It is good for my eyes. Obviously there are better mini red dots but this one seems to be pretty reasonable between performance and cost.

Cheekweld is good. I had the Bradley cheek piece for the higher CASM mount while waiting for this one to come in.

http://i.imgur.com/JJ8Pw88.jpg?1

SteelGreyML
February 08, 2017, 20:40
I like that a lot too. If you would not mind, please tell us how you got it on the rifle. Was it very difficult? Are you going to use a rising cheekpiece with it?

TIA,
Jarhead

Thanks Jarhead. It is a very easy install. It took me time 'cos I was not wanting to mar any of the surfaces. Having done it now, it would only take me 5 minutes. I think it took about 45 minutes today 'cos of the very tight windage screws fitting into the Hopco block. I was very hesitant to tap it in with a rubber mallet; one of the small gunsmith ones.

No cheekpiece needed. Took off the Bradley.

Here is a video: https://www.youtube.com/watch?v=-okpM1-M73g