PDA

View Full Version : ar15 barrel swap


Bell9440
November 26, 2015, 22:06
has anyone figured out how to mod the barrel extension on an ar to fit the daewoo dr200?

jam762
November 28, 2015, 10:18
http://www.falfiles.com/forums/showthread.php?t=300269

Search is your friend ;)

Welcome to the files!

Bell9440
November 29, 2015, 17:23
http://www.falfiles.com/forums/showthread.php?t=300269

Search is your friend ;)

Welcome to the files!

I searched it. I have read ever post on this. Moses said in that post that he would not say what he does to the extension. I was hoping someone else had figured it out.

vandal968
November 29, 2015, 20:26
I was hoping someone else had figured it out.

I'm pretty confident that what's being done is just turning that shoulder off the AR barrel (it's in the wrong place for the Woo), then grooving for a snap ring in the correct location. Seat it in the upper, then mill the hole for the pin that actually holds the barrel into the upper. Shouldn't be bad at all.

cheers,
c

Bell9440
December 02, 2015, 21:12
I thought about that. I am a little leery of trusting a snap ring, but there should not be anything tring to push the barrel into the receiver.

vandal968
December 03, 2015, 20:26
The barrel is actually held to the receiver with a pin, just like an AK. The snap ring would just be to hold the depth adjustment while milling and provide a little extra bearing surface.

cheers,
c