PDA

View Full Version : Spare Parts ?


Northwoods
May 09, 2014, 05:58
I have.one of older ($350 new from SOG) Woo folders and a DR 200. What parts are common to both? I have never had anything break but who knows.

Jarhead504
May 09, 2014, 22:01
All semi-autos are hard on extractors. Must have for any semi-auto also include firing pins, triggers or trigger/sear assemblies, hammers, spare sights; both front and rear, especially front, and any and ALL PINS AND SPRINGS, which in the event of LOSING THEM whilst disassembling the rifle will turn your $1K+ rifle into a $1K+ club! An op-rod, pistons with springs and a spare bolt, properly headspaced wouldn't hurt either. Stock pieces can crack or break so having some of them around in a safe, environmentally controlled area is a good idea.

I don't know if the DAEWO has them on the bolt, but the gas rings that the AR's use wear out and need replacing on some rifles more than others.

Jarhead

Northwoods
May 10, 2014, 08:00
Is anyone still making charging handles?

s0b3
May 10, 2014, 15:46
Is anyone still making charging handles?

http://daewoorifleparts.com/index.php?main_page=product_info&cPath=6&products_id=70

http://daewoorifleparts.com/images/K1stdnOSCH1.jpg

Northwoods
May 14, 2014, 08:55
Thanks for the info

Story
June 12, 2015, 15:29
High Weirdness.

Looks like a Daewoo bolt, doesn't it? Only problem is that the hole for the cam is 90 degrees out of phase, which to me means that it'd eject down/to the left.

http://i.imgur.com/KyJU7m1.jpg

So is this for a bullpup or beltfed?

mountainman
June 17, 2015, 17:38
Woo people never got back to me regarding the extractors. I take it these are like an AR just longer? Good close up pics would help me figure out what it takes to make these.

Syntax Error
June 19, 2015, 00:35
Woo people never got back to me regarding the extractors. I take it these are like an AR just longer? Good close up pics would help me figure out what it takes to make these.

I was able to fit a normal AR-15 extractor on a Woo bolt, but the tail end was short. However, the claw end lined up properly with the extractor installed with the pin in the bolt, and was able to extract rounds. I can take pictures if you'd like.

Story
June 30, 2015, 18:51
High Weirdness.

Looks like a Daewoo bolt, doesn't it? Only problem is that the hole for the cam is 90 degrees out of phase, which to me means that it'd eject down/to the left.

So is this for a bullpup or beltfed?

<iframe width="420" height="315" src="https://www.youtube.com/embed/f4zyjLyBp64" frameborder="0" allowfullscreen></iframe>

Story
October 20, 2015, 11:07
Turns out it was a Gwinn Bushmaster bolt.
http://ar180s.com/?p=449