PDA

View Full Version : Feg hi power issue


croftonaviation
April 07, 2014, 07:35
Hey all
I have a mid 80's feg hi power clone. The trigger axis pin walks out on it. I was thinking the first step would be to replace the trigger spring. Any other ideas are appreciated, before I start ordering parts.

Thanks

Tom

JasonB
April 07, 2014, 09:32
I bet someone knows what the issue is. I will recommend ordering all new parts hooking in to the trigger group from Brownells.

hairygreek
April 07, 2014, 17:04
Peen it into place?

fiream29
April 22, 2014, 18:29
The very first thing I'd do is order a new trigger pin from Browning or Brownells. Pick up some new springs while you're at it to spread shipping cost. If the new pin is still too loose, it's going to need more serious attention. To keep from making a bad situation worse, you might want to let a gunsmith familiar with the HP style look at it.
Good Luck!

Sagerider
May 11, 2014, 21:21
The trigger pin is held in place by the trigger return spring resting in a groove in the pin. I had the same issue and replaced the pin and spring which solved the problem. Good luck. :)