View Full Version : Thumbhole stock, removal what screws (PIC)

February 07, 2009, 23:15
Hey guys...screwing around with this lower tonight. I have the spring and nut removed from the rear. I can't figure out what else needs to be removed.

I have these two square bolts.


Also this one a hex-head under the hammer/plunger.


Are these the ones that have to be removed??? Any others???

Also does the butt-stock remover have the head to remove the square head bolts???

For some reason I'm banging my head against the wall with this.

Thanks Matt

February 08, 2009, 15:29
The one in 2nd picture under the FCG, also the one on grip to remove the trigger guard.

February 10, 2009, 23:06
once you get that off, bet you won't want to put it back on.
wood or pebblegrain? how about both for different occasions or moods.

If you buy a surplus pg - wood or plastic, you might have to replace the trigger return spring
( under the little plate under the screw inside the trigger guard in your 2nd photo). Century used
a longer one to fit their stock.I just cut 1/4" off it.

February 11, 2009, 12:13
You can use a spring from mechanical ball pen/pencil. Works great and better trigger feel.

February 14, 2009, 21:21
Did you just pick up that thumbhole? If so, and not to tromp on your post or anything, but what did you pay for it? Thanks.

February 16, 2009, 04:37
Thanks for the info...

I still haven't taken it off yet.

I got side-tracked this week. I do have some parts headed this way so hopefully I'll be done in the next few days.

bronco_buster...I bought this about 10-12 years ago. Paid $250 with extra parts and some ammo.

Finally getting off my butt and changing it up.

February 17, 2009, 08:24
Originally posted by leadnbrass
Paid $250 with extra parts and some ammo.

THat made me feel very jealous.

February 21, 2009, 11:10
:p Green with Envy.