PDA

View Full Version : fal bolt


farmer2010
January 23, 2009, 01:38
think I FOUND THE ISSUE OUT ON MY CA FAL looks like some fool ground down the spur on the sand cut BOLT CARRIER, BOTTOM ANY ONE EVER RUN IT TO this had this gun 4 years now, shot about 1200 rds out of it finding info out on the page helps , But makes me sick as i find new stuff out, WOULD I HAVE TO HEAD SPACE for a new sand cut bolt carrier, please reply,

garandguy10
January 23, 2009, 02:28
Are you talking about the little dohickey that trips the Safety Sear? If so you likely do not have a Safety sear to trip in your Fal if you are in the USA and you have no Fed Tax paperwork for your Fal. And if you do have a Safety sear installed with no paperwork to go along with it,then you might want to not bring the subject up again.

Also replacing a Bolt Carrier in a Fal rarely changes the headspace too much.

farmer2010
January 23, 2009, 16:03
I READ A LIITEL about it, the receiver is Not A sear cut,