PDA

View Full Version : DSA Para Lower parts question


jaflowers
July 20, 2008, 23:03
Thinking of getting the DSA Para Lower with stock to turn my G1 into a Para. Other than the obvious bolt/topcover and recoil springs in the upper, are any of the parts in the lower receiver different than the standard rifle lower receivers? I'm talking about the hammer, trigger, sear, trigger guard, plunger.....etc. Thanks guys.

SIG552
July 22, 2008, 05:45
No, that stuff is all the same. The para does have a different rear sight however. DSA sells those too.

jaflowers
July 22, 2008, 13:10
Thanks. After a ton of reading all over the net I was coming to the same conclusion but I just wanted to be sure that if I bought a stripped lower I could just use my internals. Appreciate the help.