PDA

View Full Version : Ok, Ready to Build. 1st problem


rotor2
July 18, 2007, 20:41
Barrel only times to 9:30. So I assume I'll have to sand some of the barrel shoulder down. As said here. http://www.cruffler.com/trivia-April01-assembly.html

Thanks

XHardrock
July 18, 2007, 21:25
Exactly.
It's covered very well here if your up to the research.

rotor2
July 18, 2007, 21:27
I can still wiggle a peace of paper between the barrel shoulder and the receiver.

And it looks like its the end of the barrel is what is stopping the barrel from going more.

So what do I do? Start sanding the end of the barrel?

rotor2
July 18, 2007, 21:32
OK,

From what I have read from past threads. I cant just sand the barrel shoulders, because my chamber end is tight up against the rec.

Its not the barrel shoulders thats preventing the timing. But the ass end. As Radio would say.

How do I go about fixing this?

Thanks

rotor2
July 18, 2007, 21:53
Its a Imbel 2003 rec. Metric. on a Imbel Barrel.

W.E.G.
July 18, 2007, 21:57
Originally posted by rotor2
I can still wiggle a peace of paper between the barrel shoulder and the receiver.

And it looks like its the end of the barrel is what is stopping the barrel from going more.

So what do I do? Start sanding the end of the barrel?

See http://www.falfiles.com/forums/showthread.php?postid=1960113#post1960113

rotor2
July 18, 2007, 22:09
Sweet! WEG

your little trick helped.

Now it times to 10 o clock, and paper dont fit in between the reciever and barrel shoulder.

I read through that thread. And did not bother to try it. But then you pointed it out again. So bam.

Thanks

rotor2
July 18, 2007, 22:48
Ok, Now that it times to 10 oclock. Do you think it will be alright to try and torque it to 12. Or should I keep working till it times to 11?

Thanks for all the help

-Rotor

jaykden
July 19, 2007, 01:24
it'll be on the loose side if you can hand tighten it to 1100

i perfer 10-1030 myself