View Full Version : bottom rail issues
June 26, 2007, 14:28
Hello, well I bent my flat and it turned out ok, with my home made fixture. Unfortunatly it is not quite deep enough, and in order to get my bottom rails lined up with the front trunion I'll need to open up the holes on the rails to get them to line up with the holes on the receiver. Is this a show stopper, or will it some how work out with this mod?
June 26, 2007, 14:39
Is it because you bent the top rails are too low, or because you made the receiver too wide?
Either way, it would seem to me that your bigger problem is that your FCG is now too high and may interfere with the carrier. Also, your mag will now sit higher in the receiver which will change its geometry with the bore and bolt.
June 26, 2007, 15:15
I made it a touch too wide. I figured, it would snowball from here. $12 down the tubes, thinking I better order a DCI.
vBulletin® v3.8.7, Copyright ©2000-2016, vBulletin Solutions, Inc.