PDA

View Full Version : Metric follower in Inch magazine ?


JJC
June 11, 2007, 23:33
I recall a thread that stated you could replace the follower and spring from a Inch magazine with the follower and spring from a Metric mag.

I assume the only reason to do this would be to add a 922r part to an inch rifle. Has anyone actually done this ? if so any reliability issues ?

Finally, who has US made mag followers ? I have found lots of US inch floorplates , but not followers.

Thanks

1006587
June 12, 2007, 07:15
I did one mag using a Falcon Arms follower and their Black Maxx spring. It works fine but I haven't used it extensively.