Timber Wolf
December 16, 2001, 17:13
Just got these in. First impression, very light. Tried three different Inch barrels and breeching washers and they all time up at about 10 to 10:30. I guess I need to thin a washer. The locking shoulder hole appears to be too small. Only one of three locking shoulders I tried would even begin to hand start into the hole. This shoulder is also the only one which the "head" would fit into it's recess (turning the pin around for testing). Of course I do not know if this pin will be the correct one to headspace the rifle yet. Jury is still out, might build up OK but the shoulder hole has me worried.
The mount I think is a winner. Fits perfectly on the William's Inch and a Federal Type 1. A little short on an Entreprise Type III (the Entreprise must be long of course). Also fits perfectly on a Imbel Inch cut receiver that I think will be it's final home. So it fits three out of four, I am happy. I will try it on an Entreprise Inch and a couple more Imbels and post if it is any differnt than those above.
I will post on how the build goes, hope I have a shoulder to fit otherwise it will take a while.
The mount I think is a winner. Fits perfectly on the William's Inch and a Federal Type 1. A little short on an Entreprise Type III (the Entreprise must be long of course). Also fits perfectly on a Imbel Inch cut receiver that I think will be it's final home. So it fits three out of four, I am happy. I will try it on an Entreprise Inch and a couple more Imbels and post if it is any differnt than those above.
I will post on how the build goes, hope I have a shoulder to fit otherwise it will take a while.