View Full Version : Anyone install their Tapco Gasblock?

September 18, 2001, 17:03
Received my new in wrap gasblock from Tapco. Now comes the fun. Any hints for an advanced WECSOG'er about fitting and drilling the hole for the pin? How much leeway does a guy have? Looks the like handguard screw hole is pretty much self guided using the guards as a template.

Any advice appreciated.


September 18, 2001, 18:40
hey DoubleTap,
i have one on the way, I was thinking of using the orig. gasblock as a template to drill the new one.
all I could think of for now.
anybody Else?

[ September 18, 2001: Message edited by: R1Fal ]