View Full Version : Need Underfolder Template
September 24, 2006, 08:14
can anyone point me to a template for cutting the underfolder holes in the correct location?
September 24, 2006, 08:48
You can make your own underfolder template from the underfolder trunnion. Take a stiff piece of paper (like a post card) tape it to the back of the rear trunnion and fold it over the sides of the rear tunnion. Then take a ball peen hammer and carefully hit around the holes and cut outs in the rear trunnion. Once finished, the paper now has been cut to match the holes in the rear underfolder trunnion.
To use, leave the paper taped to the rear trunion and insert trunnion into receiver with the paper on the outside. Then fold paper along the side of the rear of the reciever.
A word of caution, sometimes the paper template will move alittle as the rear trunnion is place into the back of the receiver (happend to me twice). Solution, be careful and drill small holes first and then enlarge as needed.
September 24, 2006, 09:09
You can use wide masking tape as your template paper too.
It comes with its own adhesive.
September 25, 2006, 12:25
I'll just have to use the trunions, and drill small to enlarge..
vBulletin® v3.8.7, Copyright ©2000-2014, vBulletin Solutions, Inc.