locking shoulder sizes ( face and shaft )

[bullsear]

What are the commonly available sizes for locking shoulders? How small do they go?
Thanks

[ September 09, 2001: Message edited by: gary.jeter ]

[KP]

Look at the Spiral Fab website. They have a list of locking shoulder sizes. members.nbci.com/spiralfab............ Hope this helps. Also, download Gunplumbers shareware document on building the FAL............

[Noname]

I use the INCH form of ID. All LS interchange.
Nominal----1 (.2590) to 15 (.2750)
Nominal----OD .2970
1ST oversize- 1/1 to 15/1----OD .2982
2ED oversize- 1/2 to 15/2----OD .2990
3ED oversize- 1/3 to 15/3----OD .2998
It is not unusual to mill a custom size. Usually .2540 and .2560. My personal best was a .2420 to head space a first gen Entreprise.

[ August 11, 2001: Message edited by: Noname ]

[TNT ARmoury]

KP,
The www.members.nbci.com/spiralfab (http://www.members.nbci.com/spiralfab) page came up as an error. Is that thte proper url?

[Dano]

Try this...
http://members.nbci.com/spiralfab/

[W.E.G.]

btt

[kent158]

I still can't seem to get to the spiral fab web page. All I get is an error?