PDA

View Full Version : can an FNC trigger job be done ?


zeichstein
September 12, 2001, 14:50
It seams that the trigger pull on an fnc is a combination of the trigger return spring and the hammer sear spring. I have experimented with lighteneing the trigger return spring and it does reduce the pull from 12 pounds to 8 pounds.... however, The sear spring is to strong and the trigger spring can not move the trigger to the full forward position... the safety lever can not be engaged...
Is there a spring set (Both springs) that are lighter but where the trigger return spring is heavier than the sear spring?

zeichstein
September 13, 2001, 11:12
BTT