View Full Version : Para Cover reliefs?
April 04, 2002, 22:40
Does anyone have a detail drawing of the reliefs needing to be cut in the upper reciever to accomodate the Par Cover? TIA
April 05, 2002, 00:18
I just slid it up flush and needle scribed it around and then made an X off of the center and then mic'ed the width and depth adding a thousandth and Brrrrrr,done.It's not critical except that it has to be centered properly and cut deep enough.
April 05, 2002, 01:58
I have no idea how original/correct you want your rifle to be but have you considered just filing about +- 1/8" off the front nib of the cover - just 'nuff so that it slides in to fit flush at the rear? It takes two minutes and if the cover is too loose on the receiver (so that it backs out when you pop the rifle open) then it is another 1/2 minute to fix that.
vBulletin® v3.8.7, Copyright ©2000-2017, vBulletin Solutions, Inc.