View Full Version : How do you change cocking handle knob??????
February 22, 2001, 13:50
I want to order a u.s. cocking handle knob & rivet from dsa. Can anyone tell me how to change this over???
[ September 10, 2001: Message edited by: gary.jeter ]
February 22, 2001, 16:17
drive the pin out holding the plunger and spring, pull them out. take a drill and drill the rivit out from the back and pull it off. put the new one on, and place a small socket on the large part of the rivit and use a large punch to flatten the rivit from the underside. its pretty easy to do
Jeffrey K Hampshire
February 22, 2001, 16:21
does the US made knob and rivet qualify the whole assembly as US made, or is it just better? Seems like a cheaper alternative to replacing the entire cocking handle if so.
February 22, 2001, 16:33
Thanks Woodie I thought so just wanted to check.
February 22, 2001, 16:39
i wish just the knob was a US part, but you have to replace the whole frickin thing
September 10, 2001, 20:20
moved to FAQ
vBulletin® v3.8.7, Copyright ©2000-2013, vBulletin Solutions, Inc.