Tapco stripper mount

[jerrymrc]

Well I got to try my mount out today on the .243 FAL and noticed something.
The brass was going forward.

Did not think about it till I came home and noticed a dent right in the middle of each case. Looking at the cover I see where the brass is hitting the sharp edge on the right hand side of the cover and pitching them forward.

Anyone else seen this? Not sure if I want to grind on it or work on the ejector.

[Valkyrie0002]

Even the std Tapco cover does this. The walls are much thicker and catch the brass more so than the OEM covers.

[HawaiiFALer]

Originally posted by jerrymrc
... Looking at the cover I see where the brass is hitting the sharp edge on the right hand side of the cover and pitching them forward.

Anyone else seen this? Not sure if I want to grind on it or work on the ejector.
It does that with my standard TAPCO cover. You could grind a relief to thin down that area, or you could glue on a "bumper" of some sort. I would not want to change the ejector.