Fault Zone
January 17, 2006, 18:16
Just want to post a special thanks to Rich at CGW. Last Sunday, I stopped by to drop off two STG parts kits, U.S. parts, etc. at the ol’ CGW shop. Rich had the propane heater turned up and the Steeler game on. So we sat and shot the bull for a while and watched the Steelers build a 14 point lead. Speaking of “build”, there was a lot of nicely refinished Imbel goodies lurking about the shop. I’m sure some folks are going to be really happy in the next few weeks.
Rich also loaned me his miter saw so I could install some chair rail moldings in my new house. That saved from either: 1) buying a new one, or 2) renting one. When I asked Rich when I could return it he said to have it back by spring. I hope it doesn’t take me till spring to install 50 LF of chair rail, with four - ninety degree corners, two – forty five degree corners, and three coped joints.
Rich, as always it was a pleasure to hang out, do our business, and see the dogs!! Thanks again for letting me borrow the miter saw. Wish me luck this Saturday…by 4:00 PM I want the moldings up, level, nailed and touched up with paint, 10 fingers on my hands, and a cold beer staring at me from the new fridge.
Fault Zone
Rich also loaned me his miter saw so I could install some chair rail moldings in my new house. That saved from either: 1) buying a new one, or 2) renting one. When I asked Rich when I could return it he said to have it back by spring. I hope it doesn’t take me till spring to install 50 LF of chair rail, with four - ninety degree corners, two – forty five degree corners, and three coped joints.
Rich, as always it was a pleasure to hang out, do our business, and see the dogs!! Thanks again for letting me borrow the miter saw. Wish me luck this Saturday…by 4:00 PM I want the moldings up, level, nailed and touched up with paint, 10 fingers on my hands, and a cold beer staring at me from the new fridge.
Fault Zone